Maintenance Of Pneumatic Components

A pneumatic component equipment maintenance not carried out then it will reduce the life, brought about by the failure of the serious security risks should not be underestimated, so how do you maintain a good set of pneumatic component equipment?
1, to ensure that the right of the gas supply system: the entrance to the inlet pressure to the tool (non compressor outlet pressure) generally 90PSIG (6.2Kg/cm^2), too high, too low are detrimental to the performance and life of the tool. Air intake must contain sufficient lubricant, for full lubrication of pneumatic motor tool (you can put a white at the tool exhaust review whether there is oil, normal for the oil). Air intake must do without water, if reduced air without the air dryer is not appropriate.
2, can't operate any parts after demolition tools, will affect the operator's safety could result in tool damage.
3, if the tool slightly failure or by using the original function is reached, can no longer continue to be used to check immediately.
4, using a variety of tools, be sure to follow all safety rules and instructions.
5, in order to choose the proper tool, tool easily hurt, too small to easily cause tool damage.
6, periodically (about once a week) inspection, maintenance tools, adding butter to the rotating parts such as bearings, add the oil in the air motor parts.